Steve C Posted October 25, 2020 Posted October 25, 2020 Hi, I recently brought an Audi A4, Petrol, Automatic, Cabriolet, 2005. I have been struggling to clear an intermittent ABS fault. When the fault is active I have scanned the car and the fault was the left front wheel speed sensor. I replaced this and the fault is now less frequent but it still happens. I waited until the fault was active again and rescanned the car and the same fault the result. I can reset the fault by turning off/on the ignition Does anyone have any idea what to do next? Cheers Steve
Steve Q Posted November 9, 2020 Posted November 9, 2020 As you've had the sensor replaced. I'm wondering if it's the wiring that's come loose?
Magnet Posted November 9, 2020 Posted November 9, 2020 Hello Steve C, Not sure about the set up on the front, but the rear (ABS) is often signalled by a weak magnet built into the hub, and it is this rather than the sensor itself which can be at fault. Similar set up with speed sensor? Kind regards, Gareth.
audia4b5kev Posted November 9, 2020 Posted November 9, 2020 clean the end of strobe bit and the abs ring bit muck gets in some times
Magnet Posted November 10, 2020 Posted November 10, 2020 All wheels Kev? Very often, ABS rings as such are not used. Kind regards, Gareth.
Magnet Posted November 10, 2020 Posted November 10, 2020 But surely, good diagnostic equipment will detect which is the offending wheel, and save you removing all (in caps) the sensors - with a high risk of breakage.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now