Jump to content


cleaning injectors


Go to solution Solved by alpha omega,

Recommended Posts

Posted

hi,the car is running a bit rough on idle and poor fuel economy,but fine while driving apart from a vibration from the rear right when seeting off in 1st gear.can anyone advise as to wether this should be left to a specialist to remove and clean the injectors and have the seals replaced. ? as always any advice grateful馃憤stephen


Posted

I guess it depends how handy you are with the spanners. As I personally would always leave it to a professional. Have you done a diagnostic check to see if any fault codes flag up聽

Posted

hi steve, sorry i should have said.yes,and no fault codes i was just leaning towards injectors as i have high mileage.i have read on here people having faults with different things on their cars and not having any fault codes come up.i know its guess work without a reading.if i was to go down the rd of injectors then yes i will leave it to the professionals then as i am not that handy with spanners.regards stephen

Posted

Is it smoking on start up?聽

I ask as mine was (before I blew it up) and I had a suspicion it was the injector seals that had failed.聽

No fault codes and she ran fine.聽

Posted

yes but black smoke and now its not reving much lol just going to put the code reader on it will be back soon

.....update.....loose connection to maf not sitting right revs back to normal.will book it in a garage and see what they think.thanks for now

Posted

update got it booked in with an audi technician this week will let you all know the outcome馃槀 how much馃槷lol

Posted

sorry for the even later reply steve here are the results from audi(拢99 health check)...馃槀馃槀馃槀no mention of dpf/injectors.i could not believe they had to turn the timing back a notch馃槷 got part video on audi cam they sent me.

Posted

it feels like it steve i am going to start it in the morning and let it idle and see if it ticks over ok will let you all know thanks

Posted

started the car up and left it to idle and it now idles fine.no rough idling....i thought great,until i went to rev the car up and its only giving me 2,500rpm......taken the front bumper off this morning as i thought this pipe(see pic)had come lose like it did once and had power loss...checked the connector to the turbo all fine checked other pipes and connectors all ok.....plugged the snap on in....no codes.....any ideas please. stuck with car on ramps this morning.lol..21/05/23

20230521_073041.jpg

20230521_080459.jpg

20230521_080936.jpg

Posted

update put the car back together still 2500rpm at standstill took it for an italian tune up.it gave power when needed but no higher than just over 3000rpm still powerful enough but not the 4500 i used to have at standstill.still no codes.no warning lights on dashboard.i will have to look into what steve Q has mentioned the dpf as i have symptons of low power,bit of black smoke from exhaust,diesel fuel odour in the cabin,reduced fuel economy.i thought audi may have picked up on this on thursday the 18th of may as i asked for a health check on the engine. pleased audi realised about the timing though phew..

Posted
41 minutes ago, alpha omega said:

update put the car back together still 2500rpm at standstill took it for an italian tune up.it gave power when needed but no higher than just over 3000rpm still powerful enough but not the 4500 i used to have at standstill.still no codes.no warning lights on dashboard.i will have to look into what steve Q has mentioned the dpf as i have symptons of low power,bit of black smoke from exhaust,diesel fuel odour in the cabin,reduced fuel economy.i thought audi may have picked up on this on thursday the 18th of may as i asked for a health check on the engine. pleased audi realised about the timing though phew..

Love that, not heard the Italian tune term for a long time! Yea as I say I'd consider issue with dpf or even egr.聽

  • Like 1
Posted

strange revs have come back now. knowing my luck not for long lol

  • Like 1
Posted
2 hours ago, alpha omega said:

strange revs have come back now. knowing my luck not for long lol

Hi Steve, the car won't rev above 2500 standing because it has a built in rev limiter to stop that sort of activity and the moronic element from smashing the granny out of the cam belt and valve gear, it ain't like the old days where some used to get a kick out of listening to valve gear bounce and compression rings chattering, the whole process works on reciprocal force I.E. weight counterforce against the driven speed of the engine, the two forces balance each other out.

Steve.

  • Solution
Posted

oh my word steve thank you for enlighting me and others with your knowledge we are very grateful it now puts my mind at ease.kind regards stephen.ps just waiting for a garage to get back to me to see when they can book me in for the front wishbone arms and timing doing including the water pump

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now





  • Create New...

Forums


News


Membership


  • Insurance
  • Support