Leeroy99 Posted September 28, 2016 Posted September 28, 2016 hi just been buying a4 b6 very impressed with it so far. Having a bit of trouble with c/l ? Remote locks all doors and boot but not drivers door. And doesn't arm the alarm I've got to do it manually? 聽Also what about oil changes ? And flush the engine or not thanks 馃槈
Trevor Posted October 3, 2016 Posted October 3, 2016 Hi Lee...welcome to the Forum Possibly the central locking actuator on the drivers door at fault...worth checking the wiring harness as it goes from the A post into the door for broken wires first. I 聽would always recommend a flush to clear any deposits from inside the engine to allow the oil a better chance of working efficiently. Cheers 聽 Trevor
Leeroy99 Posted October 8, 2016 Author Posted October 8, 2016 Thanks Trevor appreciate it just I've seen some people say don't flush them as ir can cause extra damage? I will check wiring and if not you think it'll be the door motor? 聽Thanks again
Trevor Posted October 10, 2016 Posted October 10, 2016 If not wiring then more than likely the door motor
Leeroy99 Posted October 10, 2016 Author Posted October 10, 2016 Cheers Trevor appreciate it. Trevor I've been looking through the site and some people say not to flush as it can cause more damage then good my car just gone onto 100k and got a good history just unsure what to regards flush ? And best oil to use and also plugs ? Thanks lee.
Trevor Posted October 11, 2016 Posted October 11, 2016 I have never experienced any issues with using engine flush, but I alway use the one that you drain down the oil, fill half the contents (2.5 - 3.0 litre) and run the engine at fast idle (approx. 1200 rpm for around 5 minutes and drain down. Used this process/flush oil on a commercial basis in my garage business for years with no issues and it definitely cleans out partially聽blocked oilways and cures rattling hydraulic lifter problems. The 'add to oil' type flush in my mind doesn't work as well, but I cannot see how any engine oil flush or detergent flush would have any detrimental effect on an engine. The only time I would not advise to use any thin oil or flush is when a diesel engine is heavily worn and it can potentially draw the fluid past the rings and combust it, leading to a 'runaway engine'. Engine oil quality is simple....you get what you pay for! 聽Probably the best oils I have used are Mobil1 (not cheap) and Shell Helix Ultra (cheaper). Spark Plugs....either NGK or even Champion (who have now got their act sorted and producing good plugs again). Would avoid Bosch at all costs.
Leeroy99 Posted October 11, 2016 Author Posted October 11, 2016 Thanks Trevor appreciate the info. What is the name of the flush you use ? Im hoping to service it and give it a good going over this weekend. Thanks again lee
Trevor Posted October 12, 2016 Posted October 12, 2016 The one I used to use was made by Comma but not sure where you can but it from nowadays...could try a Motor Factors first.
Leeroy99 Posted October 13, 2016 Author Posted October 13, 2016 Thanks Trevor appreciate it let you no what's happening cheers 1
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now