Beany1
-
Posts
117 -
Joined
-
Last visited
Content Type
Profiles
Gallery
Forums
Events
Articles
Videos
News & Articles
Premium Membership
Store
Everything posted by Beany1
-
Can this cause slow acceleration .. where there pipe fits on throttle body I can pull pipe and it has little gap back and forth movement maybe a few mm thanks
-
Is the throttle body side of hose suppose to be bit loose where the clip fits on or is it suppose to be tight with no gap
-
Ye thanks going to have a look tomorrow if I can see part number on hose
-
Audi a4 b7 2.0 tdi does anyone know part number for the hose going to the throttle body thanks
-
Sorry not the wire meant to say the black tube found out its the breather tube for battery vent tube
-
Ye thanks magnet I found out its the battery breather tube
-
Hi got an audi a4 b7 2.0 tdi need to change battery but my battery has a wire init pictured with yellow circle what is this wire and how do i change battery as my new battery doesnt have this wire thanks
-
No vat they are a very good garage use them alot " viking motors " in rotherham they have 5 star on google thanks gareth
-
And i have a full luk dual mass flywheel and clutch kit
-
They have not given me a quote yet i just booked it in
-
Hi gareth i got my car booked in april 29th local garage clutch and dual mass flywheel im supplying parts they doing just labour car is audi a4 b7 2.0 tdi bre 140 manual i was thinking how much should i be looking at for labour and roughly how many hours is a job like this and i think they charge around 50 pound an hour thanks
-
Hi having clutch and flywheel replaced how long labour time should it take thanks
-
How long should i be looking at labour time for the fitting thanks
-
Thank you gareth yes got whole new 3 piece luk clutch kit and dual mass flywheel luk too going in next month on 29th thanks
-
Like this one
-
Hi yes the clutch plate it has 4 springs on it are the suposed to have little movement in them ands its luk thanks
-
Hi are the springs in clutch disk suposed to have little movement
-
Ye im getting vibration at idle and like slight rattling noise but drives good hope it sorts the problem out and thankyou very much jason
-
Ye apreciate it and thanks for all your help and advice jason and with my torsion being that far out what symptoms will i be getting
-
This is the only sticker i found on cam cover dont know if it means anything but i have found a remap tuning company that is gonna adjust the torsion value for me as they have all the diagnostic tool as i rang them and told them my torsion was at -3.6 he asked is it a pd engine it needs to at 0.0 or close to he booked me in for wednesday 50 pound to sort it out
-
-
If i dont find sticker on cam cover with value range for my engine how do i go about setting torsion what should i set it at thanks
-
My engine is a bre 2.0 tdi
-
I checked it on vcds vagcom torsion showing -3.6 i have not touched the bolt or nothing yet and not looked for sticker on cam cover i will check in morning what should i look for on sticker
-
Yes thank you jason exactly what im looking for when i get it to 0 how do i know its right and not out of range i heard when its at 0 and you rev the engine the number should move and if it stays at 0 and dont move its out of range thanks
