Good afternoon all,
It's been a while since I've been on here. I'm looking for some help if possible, multiple garages can't diagnose whats wrong.
The car: Audi A6 C6 2.0 TDi 168bhp - 2010 model - Saloon - 115k Miles
Car overheated one day, no heating at all. Red message saying low coolant or something similar, car was at 110/120 degrees. Booked into a local garage.
I had the cambelt and waterpump changed as the waterpump had a crack and was leaking.
Collected the car, the second I hit the motorway it did the same thing again, overheated with the red coolant low message.
Garage said it has to be the the EGR Cooler, new one put on, collected, same message again as soon as I hit the motorway.
Back into the garage, this time they said we'll change the Heating Auxiliary pump and put on a new genuine Audi thermostat as its probably that.
New pump and thermostat on, collected, does exactly the same again.
Cars Routine:
- Cars completely cold, top up coolant, start it up, no message or issues. But no heating at all.
- Other scenario, I’ve topped up the coolant, run the car, burped the system, then topped up, then closed the cap, spits out the coolant even quicker than usual. I’ve done this around 4/5 times and it takes ages for the coolant to drop.
- Drive it to work which is around 6/7 miles, mixture of 30mph and motorway. If it goes above 2,000rpm for more than
5/10 seconds whilst in Drive or in gear, I get the coolant message and coolant will spit out of the expansion tank making the coolant level low whilst driving. This took me ages to figure out after multiple stops to top it up. So you're driving, coolants topped up, the cars been driven over 2,000 RPM for a small amount of time or very close to it and you get the message and the coolant will spit out just below the coolant cap. Its not until you stop and look you can tell its been spitting it out.
- Once I get the message, I stop the car and look under the bonnet, the coolant is below the minimum line and you can see where the coolant has spat itself out in the engine bay.
- Sometimes I get heating but only when the coolant is low but only on fan speed/level 1 and they have to be on the forward facing vents, anything higher than level 1 and will come out cold. if I switch the fan position to windscreen, you just get freezing cold air, it never gets warm. Everytime I top it up to the max line, I get no heating at all. I only get heating once the coolants been spat out and it’s below the minimum line and I don't top it up.
- I can have the heating working on level 1 providing I don't exceed 2,000RPM. The second I go over 2,000RPM, it just blows out cold for the rest of the journey. There's no way of getting the heating back.
- I can drive the car however, I can't drive it over 2,000 rpm or the coolant will spit out and the temperature then starts to raise until the thermostat kicks in.
- Once the thermostat kicks in, the temperature drops but only once my foot is completely off the throttle and the fans are on the windscreen full speed which is a right headache if you can't stop. It will not cool itself down whilst the throttle is down, you ahve to come off the throttle for at least 15/20 seconds to 60 seconds then it will drop back to 90 again and you can drive again but under 2,000 RPM.
It's proving to be an absolute nightmare as i'm coming out to the car completely frozen from the weather without any heating. I use 5 to 10 litres of water on cold mornings to defrost the car, then it just fogs up for the entire journey.
I've spent over £2,000 already trying to get this sorted, I can't just chuck it into another garage and spend another £500 for it to be wrong again. If anyone has any ideas that would be great, many thanks in advance.
Happy to provide photos if that makes things easier.
