Search the Community
Showing results for tags 'clutch slip'.
-
Hi All, My car has started to give gearbox issues unfortunately. The symptoms were at the start that I was driving on a long journey from near Peterborough to Blackburn, when on the M60 the car started jerking from the front and loosing power. As I drove further, the problem worsened and the car was loosing power further., so I pulled up at the hard shoulder and decided to unpower and car for a few minutes. After starting the car again, the problem was still there but gradually got worse and eventually lost momentum and did not want to move. The engine revs fine in park. At this point, I got the car recovered to a garage. The following day the car drove absolutely fine but the diagnostic stated the below P1764:00/05988:000 Passive/Sporadic Transmission temperature Monitoring I decided to go to the garage and drive the car when a few miles down the M65 the car started jerking from the front again, so much that I have to drive the car back to the garage at less than 10 mph (seems like the problem gets worse as the car heats up). The mechanic had a further look and pulled another fault code, P1743:00/05955:000 Active/Static Clutch Slip Monitoring, Signal too high Can anyone help me out what the solution may be, or does anyone know where I can a gearbox for it? I am checking ebay and the usual places but being on a specialist forum maybe you peeps know something better? I appreciate I may have to purchase another gearbox which is a solution or get this to a specialist repair centre where it will cost too much to repair for an old car like mine. Already been quoted approx. £2k for repair if this is a clutch issue. Please please can anyone help? Also, does the gearbox have to fully match up with a replacement, ie does the WWO 5 need to match up also and the T at the end of 01J301 383 T? Regards, L. Matadar
- 2 replies
-
- jerking
- temperature
-
(and 3 more)
Tagged with:
-
Every morning the car drives off but when you rev it, it won't go just crawls and the more you rev it will increase upto 60km/hr or so and also you can change gear with the paddle but it don't doesn't engage the clutch fully and go. I've taken it to Audi Garage but no faults show up. Any ideas of what could be causing this ? Tried changing the gearbox oil, double checking its full up. Very frustrating and for the rest of the day it will drive fine each time you start it.
-
Hi looking for advice got a Audi s3 8p just out custom exhaust turbo back now clutch is slipping looking for updated clutch was looking at helix organic clutch kit before I buy one any other recommendations thanks matt